Digital Networks MultiSwitch 948TXG Especificações descarregar pdf (Página 28)

Installing the Card

2-4 Installing Modular Media Interface Cards

Installing the Card

To install a card into the module (Figure 2-2), complete the following steps:

Step Action

1 Attach one end of an antistatic wrist strap to your wrist and clip the other

end to the chassis ground (for example, a screw on the side of the

chassis).

CAUTION: Static electricity can damage modules and electronic

components. DIGITAL recommends using a grounded antistatic wrist

strap and a grounded work surface when handling any modules.

2 Remove the dust caps from the card, if necessary.

3 Hold the card by the edges on the bezel and position it so that it is

parallel with the slot opening.

4 Insert the card into the slot opening and slide the card along the card

guides until the bezel is flush with the module.

Note:

To prevent the screws from interfering with the card insertion,

make sure that the captive screws on the bezel are partially threaded

into the bezel threads.

5 Firmly fasten the card to the module with the two captive screws.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 99 100

Sem comentários

Digital Networks MultiSwitch 948TXG Especificações Página 28